heat of explosion
英 [hiːt ɒv ɪkˈspləʊʒn]
美 [hiːt əv ɪkˈsploʊʒn]
网络 爆热
双语例句
- I feel the heat of the explosion.
我还是能感觉到爆炸。 - The vacuum heat collecting tube is always full of heat medium and can not burn out, thus avoiding explosion of the tube.
真空集热管内热媒始终是满的，不会发生空烧问题，避免了爆管的发生。 - On the basis of heat points initiating mechanism of explosion, micro air bubble is embedded in explosive of expanded AN.
膨化硝酸铵自敏化理论是膨化技术发明的核心，它是基于热点理论把微气泡植入硝酸铵炸药中。 - The result shows that the relationship between heat of explosion, explosion temperature and contents of KCI is linear.
结果表明，该炸药的爆热和爆温与氯化钾含量在适用范围内呈线性关系。 - The heat of explosion and specific volume of industrial explosives can be calculated by summation of corresponding component parts.
文章叙述用相应的组分贡献量，按用量系数相加，计算工业炸药爆热、爆容的原理和方法。 - For this kind of RF, the compartment air only has direct heat exchange with the secondary cooling medium, and does not contact with the refrigerant, so the risk of inflammation and explosion is reduced to the least.
对于该型式的电冰箱，箱内空气只与二次冷媒进行热交换，与可燃性制冷剂不直接接触，因此，大大降低了电冰箱采用可燃性制冷剂燃烧爆炸的危险性。 - The result indicated that the delivering heat of gas explosion can be divided into four parts: ① Turned into delivering heat of wall by convection and heat radiation;
研究结果表明：瓦斯爆炸释热可分为4部分：①通过对流、热辐射变成了壁面散热； - The mechanical process could result in the local ignition of explosive under the specific conditions. Calculation of Heat of Explosion and Specific Volume of Industrial Explosive by Component Accumulation Method
这些力学变化在一定条件下导致炸药局部爆炸。组分加和法计算工业炸药的爆热和爆容 - The results show that NiAl is formed through solid reaction between Al and Ni. The formation heat of NiAl was used to ignite reaction between Ti and C to form TiC. Al-Ni obviously reduced the start temperature of Ti-C explosion reaction.
结果表明：在Ti-C-Al-Ni体系中Al、Ni间发生固态反应生成NiAl，所放出的热量引发Ti、C间反应生成TiC：Al-Ni明显降低Ti-C热爆反应起始温度。 - Methods of Measuring the Heat transfer Parameters of Liquid Propellant Explosion Fire Balls
液体推进剂爆炸火球热传递参数的试验测量技术 - Experiment Study of the Coupling Effect between Film Boiling Heat Transfer and Evaporation Drag around a High-temperature Particle in Cold Liquid during Coarse Mixing Stage of Vapor Explosion
蒸汽爆炸粗混合阶段冷液中高温球传热阻力耦合特性的实验研究 - The highness of steam pressure of the heat supply and the problem of manufacturing qualities, when the softening kettle is running in test, cause explosion.
软化锅在试运行时由于供热蒸汽压力高及制造质量问题导致爆炸。 - This paper describes major working property of model BR-1 heat-Insulating type explosion heat measure system and measuring results of explosion heat of some explosives.
本文介绍了BR-1型绝热式爆热测试系统的主要工作特性及部分炸药的爆热测试结果。 - Performance of anti-corrosion and heat resistance of FeAl-based plasma spray coatings prepared by electro-thermal explosion method
FeAl系电热爆炸喷涂层抗高温氧化腐蚀性能对比 - Research of Anti-corrosion and Heat Resistance Performance of Electro-thermal Explosion Plasma Spray Coating of FeAl Base
FeAl系电热爆炸等离子体喷涂层高温耐蚀性能研究 - The dependence on the heat-transfer conditions ( Biot number Bi) of the temperature gradient at the surface, Γ, of an exothermic reactant mass at criticality for thermal explosion is presented.
讨论了放热反应物在满足热爆炸条件时临界表面温度梯度Γ（cr）和热传递条件（Biot数Bi）的关系。 - An experimental study on heat processes propertes of liquid propellant rocket explosion
液体推进剂运载火箭爆炸热过程特性试验研究 - According to the demands of green chemistry and atom economy, as well as introduction new concepts the unit mass explosion heat and the unit mass gas volume of explosion products, the raw materials, formulation and explosion products are discussed.
根据绿色化学和原子经济性的要求，引进新概念爆炸产物的单位质量生成热和单位质量比容，对工业炸药的原材料、配方、爆轰产物进行了分析。 - Calculation of Heat of Explosion and Specific Volume of Industrial Explosive by Component Accumulation Method
组分加和法计算工业炸药的爆热和爆容 - Increasing Toughness of Heat Affected Zone in Welded Joint of WD Steel by Pre-Welding Explosion Treatment
爆炸预处理提高WD钢焊接接头热影响区韧性的研究 - The heat transfer model of the discharge has been established, and the removal rate could be significant promoted because of the explosion with the method of thermodynamic finite element analysis.
建立了电火花放电加工的热力学传导模型，通过有限元仿真方法得出具有放电爆炸力的单次脉冲能够明显提高难加工材料蚀除量的结论。 - Therefore, a novel reactor configuration is designed to supply more heat for the reforming side by inputting methane of combustion side not only at the entrance also at different axial positions of the reactor, simultaneously avoiding the methane concentration over the explosion limit.
为了给重整侧提供更多的热量同时又要避免甲烷浓度超过爆炸限，设计在燃烧侧入口以及不同的轴向位置引进低浓度燃料甲烷，构成了一种新颖的轴向分段进料整体式反应器。